TracSafe Anti-Slip Sealer
TracSafe Anti-Slip Floor Coating lets you quickly and economically add a beautiful, uniformly colored slip-resistant finish to numerous slippery surfaces.
Reduce slip and fall risks inside & out.
No primer or sealer required. Add anti-slip protection for your customers, employees and residents while adding excellent visual appeal.
TracSafe’s distinctive decorative slip-resistant formula is fully pre-mixed, along with the stone backbone that makes it so tough. Just stir it up and roll it on.
Save on the cost of expensive concrete replacement, yearly repainting, excessive wear and salt erosion. Gain peace of mind that comes with anti-slip ratings up to twice the OSHA standard.
U/V & Heat
For even the toughest
Bonds to Ceramic Tiles
No demolition required!
Extreme Cold Resistant
Let dry for 1-2 hours between coats.
One gallon covers up to per coat.
TracSafe in Action.
Frequently Asked Questions
TracSafe Anti-Slip Sealer is an easy and excellent choice for helping you bring added foot traction to almost any surface. It is a fast and simple solution that you can apply with just a roller.
TracSafe bonds firmly to a wide variety of existing surfaces. If bonds to smooth synthetic surfaces like linoleum and ceramic tile, to pre-painted wood and concrete floors and decks, bare pressure-treated decking — plus concrete, pavers and stone.
As a result, TracSafe is a simple safety-enhancing solution you can use almost anywhere to help protect family, friends and customers.
Yes! Use TracSafe on potentially slippery interior floors subject to moisture and humidity, like laundry rooms, bathrooms, pool decks, garage floors, mudrooms and entrance floors.
For exterior surfaces, TracSafe is a good choice as well. It's a great safety enhancer for everything from porches and steps, decks, ramps, walkways, patios and pool decks — to exterior commercial grounds, play areas, store entrances, valet parking areas — anywhere that added safety is desired.
Yes you can! Just be sure that the tile and grout are clean and dry and free of soap scum and soap residue. Then just apply two coats of TracSafe.
Since the shower area is in an enclosed area with less air flow, allow 6 - 8 hours between coats for thorough drying. After the final coat of TracSafe is applied, let the coating cure for a full 24 hours before resuming use.
Only logged in customers who have purchased this product may leave a review.